Total Racing Products Ethanol Content Analyzer Standard – Universal

Our Standard Ethanol Conversion Analyzer takes up just a small amount of real estate at just 1.9 inches x 1.9 inches. Unlike the competition, it is completely sealed for weather resistance and is terminated to a single DT 6 Pin female receptacle connector for you to interface with. This means you are free to put the ECA not just inside your vehicle’s cabin but also in your engine bay. The ECA requires 12V power and ground and can supply your flex fuel composition sensor with 12V power and ground. Each ECA is supplied with a universal harness. Each universal harness is configured with a sleeved 3 foot run to connect to a flex fuel sensor and an unsleeved 2 foot run of wires that can be trimmed for your application for your switched 12V power, chassis ground, and analog flex fuel voltage output.   Pinout Pin 1: 12V Power In Pin 2: Chassis Ground Pin 3: Flex Fuel Analog Voltage Output (0.5V-4.5V) Pin 4: Flex Fuel Sensor Signal Pin 5: Flex Fuel Sensor Ground Pin 6: Flex Fuel Sensor 12V Power   ATTENTION TUNERS: Our conversion box outputs a signal from 0.5V (0% Ethanol) to 4.5V (100% Ethanol).     Not all wiring is created equally. We use TXL wire featuring XLPE insulation that is heat, flame, gasoline, grease, and acid resistant and is used in extreme temperature applications of -40°F to 257°F!